Table of Contents
Advertisement
10. Turn the DIMM so that the DIMM keys align correctly with the connector.
11. Insert the DIMM into the connector by aligning the edges of the DIMM with the
12. Install the air baffle (see "Replace the air baffle" on page 98).
13. Rotate the power-supply cage assembly back into the server. Press the
50
System x3400 M2 Types 7836 and 7837: Installation and User's Guide
8. Open the retaining clips and, if necessary, remove any existing DIMM.
9. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the server. Then, remove the new DIMM from the package.
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector. If there is a gap between the DIMM
and the retaining clips, the DIMM has not been correctly installed. Open the
retaining clips, remove the DIMM, and then reinsert it.
power-supply cage release tab and rotate the power-supply cage assembly
into the chassis.
Advertisement
Table of Contents
