Data Read/Write Mode - Brother BAS-300G-484/484SF Instruction Manual

7. USING CF CARDS

7-3. Data read/write mode

1
2
Turn on the power switch.
3
Switch to data read/write mode.
TEST indicator and CF media indicator illuminate
4
[Read/write mode list]
PROGRAM No.
Menu display
display
r 1 [-SEd]
w 2 [SEd-]
r 3 [-MEM]
w 4 [MEM-]
r 5 [-UPG]
w 6 [UPG-]
r 7 [-SyS]
w 8 [LoG-]
r 9 [-Fdd]
w 10 [Fdd-]
r 11 [-EoP]
w 12 [EoP-]
r 13 [oPFd]
r 14 [-EoP]
47
4453Q
Sewing data is read from the CF card. (*1)
Sewing data is written to the CF card.
Memory switch settings are read from the CF card.
Memory switch settings are written to the CF card.
User programs are read from the CF card.
User programs are written to the CF card.
Control programs are read from the CF card and used to update the firmware version.
Error log data is written to the CF card.
Sewing data is read from the floppy disk. (*2) (*3)
Sewing data is written to the floppy disk. (*2)
Expansion option output (*4) data is read from the CF card.
Expansion option output data is written to the CF card.
Expansion option output data is read from the floppy disk. (*2)
Expansion option output data for older models is read from the CF card. (*5)
BAS-300G-484, BAS-300G-484 SF
With the power turned off, insert the CF card into the CF
slot.
NOTE:
• Make sure the CF card is facing the correct way.
• Always be sure to keep the cover closed except
when inserting and removing the CF card. If this is
not done, dust may get inside and cause problems
with operation.
• If no valid data can be found, the CF media indicator
will not illuminate.
While pressing the TEST key, press the R/W key.
• The mode number will appear in the PROGRAM No.
display, and the setting details for that mode will
appear in the menu display.
• The initial mode is sewing data reading mode. (Refer
to the read/write mode list)
Press the or key to select the mode.
Setting items
4574Q
4575Q
(Continued on next page)