Setting The Split Number - Brother BAS-300G-484/484SF Instruction Manual

6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

6-6. Setting the split number

Pattern 1
Pattern 2
Pattern 3
4964Q
The setting for memory switch No. 403 lets you select the split mode.
[Continuous split]
Memory switch No. 403 = 0 (Split mode is enabled after split data is detected)
Memory switch No. 403 = 1 (Split mode is always enabled)
• Sewing is carried out each time in the order of steps 1 → 2 → 3 → 1 (for example, if there are two sections of split
data).
[Independent split]
Memory switch No. 403 = 2
• The pattern for the displayed split number is sewn independently.
37
If split data (data that causes sewing to pause) exists within a single program,
the numbers that are used to specify the patterns that are separated by split
data are called split numbers.
Pattern 1: Split No. 1
Pattern 2: Split No. 2
Pattern 3: Split No. 3
1. Press the
for a program that contains split data.
• The program number will flash in the PROGRAM No.
2. Depress the work clamp switch (3) to lower the work
clamp, and then depress the start switch (4).
• The work clamp will move to the sewing start position,
• The program number will stop flashing and illuminate
3. Press the SELECT key (5) so that the SPLIT No.
indicator (6) illuminates.
• The split number will appear in the menu display (7).
4. Press the
4017M
BAS-300G-484, BAS-300G-484 SF
or key (1) to select a program number
display (2).
and then the program number will be applied.
steadily.
or key (8) to set the split number.