10-5. Adjusting the needle bar lift amount
4667M
4686M
Turn the pulley (1) by hand in the direction of the arrow to raise the needle bar from the lowest position until the lowest
reference line on the needle bar (reference line B) is aligned with the lower edge of the needle bar bush (2), and then loosen
the two set screws (4) and move the rotary hook to adjust so that the rotary hook tip (3) is aligned with the center of the
needle.
10-6. Adjusting the needle clearance
4667M
Turn the pulley (1) in the direction of the arrow to align the rotary hook tip (2) with the center of the needle, and then loosen
the two set screws (3) and move the rotary hook forward or back to adjust so that the clearance between the needle and the
rotary hook tip (2) is 0.01 to 0.08 mm.
BAS-300G-484, BAS-300G-484 SF
10. STANDARD ADJUSTMENTS
4685M
4687M
4688M
56