Sewing - Brother BAS-300G-484/484SF Instruction Manual

8. SEWING

Do not allow any liquids to get onto this sewing machine, otherwise fire, electric shocks or operating problems may
occur.
If any liquid gets inside the sewing machine (machine head or control box), immediately turn off the power and
disconnect the power plug from the electrical outlet, and then contact the place of purchase or a qualified
technician.
Turn off the power switch at the following times.
If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result.
• When threading the needle
• When replacing the bobbin and needle
• When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
8-1. Sewing
WARNING
CAUTION
1. Turn on the power switch.
4674M
2. Press the
program number that you would like to use.
* Refer to "5-2. Loading sewing data" for details on
3. Depress the work clamp switch (2) to lower the work
clamp (3), and then depress the start switch (4).
• The work clamp will move to the sewing start
• Home position detection will be carried out
2159B
4. Place the article to be sewn underneath the work
clamp (3).
5. Depress the work clamp switch (2).
• The work clamp (3) will drop.
6. Depress the start switch (4).
• The sewing machine will start sewing.
7. When sewing is complete, the thread will be trimmed
and the work clamp (3) will rise.
Use a work clamp and a feed plate which will hold
the article securely so that it does not slip.
If using the standard work clamp and feed plate
and the article being sewn is slipping, take
measures to stop the work clamp and feed plate
4675M
from being slippery.
BAS-300G-484, BAS-300G-484 SF
or key (1) to select the sewing
reading sewing data from a CF card.
position.
immediately after the power switch is turned on.
8. SEWING
50