GE JB910 - Profile 30 in. Electric Convection Range Owner's Manual page 40

Before you call for service...
Troubleshooting -tips
Clockandtimerdo
not work
Possible Causes What To Do
Plug on range is not completely
* Make
sure electrical I)lug, is I)lugged,, into a lixe, properly
i_serted in the electrical outlet, grounded outlet.
A fuse ha your home
* Replace
tile fi/se or reset tile circuit breaker.
may be blown or the
circuit breaker tripped.
Oven controls improperly set.
* See tile Using the clock and timer section.
Oven will not seff-clean
The oven temperature is
• ?dlow the range to cool and reset the controls.
too high to set a self-clema
operation.
Oven controls improperly set.
• See the Using the self-cleaning oven section.
The probe is plugged into • Remove the probe from the oven.
the outlet in the oven.
(on some models)
"Crackling" or This is the sound of the • This is normal.
"popping " sound metal heating and cooling
during both the cooking and
clemfing functions.
Excessive smoking
Excessive soil.
• Touch the CLEAR/OFF pad.
Open the windows to
during a clean cycle rid the room of smoke. Wait tmtil the LOCKED light
goes oft. _4"il)e tq) the excess soil and reset the ('leau
cvcle.
Oven door wiftnot Oven too hot. • Alh)w the oven to cool below h)ckiug temperature.
open after a clean cycle
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning oven section.
clean cycle
Oven was heavily soiled. • Clem_ up heavy spillovers betore starting the clean
cycle. Heavily soiled ovens may need to sell=clean
again or for a hmger
period of time.
"LOCKED" flashes The self-clema cycle has been • (:lose the oven door.
in the display selected but the door is not
closed.
"LOCKED"light is The oven door is locked • Touch the CLEAR/OFFpad. Allow the oven to cool.
on when yon want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F--and a number You have a function error code. • Disconnect all power to the range for at least 30
orletter,'flash
seconds and then reconnect power. If the timction
in the display error code repeats, call for serxice.
4O