Table of Contents
Advertisement
Safety information
If power cord or other parts of this machine are damaged or broken, please
contact a
technician
may cause personal harm or void the warranty.
The new hose sets supplied by the appliance are to be used and the old
hose sets should not be reused.
Please do not remove the pump filter cap at the bottom
rear of the product in any situation as water remaining
in the product will flow directly out of the product.
In the event of a blockage or a failure to drain, please contact
the customer care centre for assistance.
The pump filter cap is only to be removed by a trained service
technician.
Installation & Adjustment
Please install and adjust the machine according to the directions contained in this
manual. It is very important to follow these directions for the safe operation of the
machine, and to ensure your machine is being operated correctly.
Installing the bottom plate
The purpose of the bottom plate is to sup press noise
from the washing machine during operation .
Steps:
1. Tilt the machine backwards against a wall (ensure that
the machine is well supported).
2. Place the plate onto the bottom of the machine.
3. Use a screwdriver to tighten the screw (in accessory
bag) securing the panel to
4. Once the screw is tight and the panel
the washer to its standing position.
NOTE: The washing machine has ventilation openings in the base, the product must not be
placed on a carpeted surface.
to have it repaired. Do not attempt repairs by yourself as this
the
bottom of the washer.
is
secure, return
Pump filter cap
Screw
Bottom plate
4
Front
Back
Carpet
Advertisement
Table of Contents
