Installation - Sharp FO IS125N - B/W Laser - All-in-One Service Manual

FO-IS125N

[5] Installation

1. Site selection
Take the following points into consideration when selecting a site for
this model.
ENVIRONMENT
• The machine must be installed on a level surface.
• Keep the machine away from air conditioners, heaters, direct sun-
light, and dust.
• Provide easy access to the front, back, and sides of the machine.
In particular, keep the area in front of the machine clear, or the orig-
inal document may jam as it comes out after scanning.
• The temperature should be between 50 - 86°F (10 - 30°C).
• The humidity should be between 25% and 80% (without conden-
sation).
ELECTRICITY
AC 120 V, 60Hz, grounded AC (3-prong) outlet is required.
Caution!
• Connection to a power source other than that specified will cause
damage to the equipment and is not covered under the warranty.
• If your area experiences a high incidence of lightning or power
surges, we recommend that you install a surge protector for the
power and telephone lines. Surge protectors can be purchased at
most telephone specialty stores.
If the machine is moved from a cold to a warm place...
Condensation may form on the reading glass if machine is moved from
a cold to a warm place, this will prevent proper scanning of documents
for transmission. Turn on the power and wait approximately 2 hours
before using machine.
TELEPHONE JACK
A standard telephone jack must be located near the machine. This is
the telephone jack commonly used in most homes and offices.
• The language is unclear in this part. Perhaps it could say:
"Plugging the fax machine into a jack which is not a standard ana-
log telephone jack, may result in damage to the machine or your
telephone system."
2. Connecting the handset
3. Attaching the tray
1) Attach the paper tray.
2) Attach the document feeder tray and the received document tray.
3) Attach the document exit tray.
After inserting the tray,
flip out the extension.
1 – 7
Insert the trays at an
angle and rotate back.