Table of Contents
Advertisement
Setting the Display Mode
The
button is located on the left front panel. This button is used to
Configure
access the following configuration functions in sequence:
Bandwidth Utilization
Forwarding Ratio
Filtering Ratio
Collision Ratio
Full/Half Duplex
Diagnostics
A "long press" on the
(LED indicators light up to indicate which configuration function the system is
in.) A "short press" switches from one function to the next. And another "long
press" implements the current selection.
"Long press" in this user's guide means pressing the Configure button for
more than 2 seconds and then releasing it. "Short press" means pressing
the Configure button and immediately releasing it. Also, note that if this
button is not pressed within 10 seconds, the system will return to normal
operation.
SwitcHub-2s User's Guide
The percentage of LAN bandwidth utilized.
The percentage of packets that are forwarded to the
other port.
The percentage of packets filtered because the
destination is in the current segment.
The percentage of collisions occurring out the total
packets transmitted by the port.
Sets port communication mode to full-duplex or half-
duplex operation.
Tests the status of various system components.
button is used to initiate basic configuration.
Configure
Hardware Installation
3-5
Advertisement
Table of Contents
