Xerox C8 - DocuPrint Color Inkjet Printer System Administration Manual page 80

1. To o ls M od e
In this example, the
Upper 10 mm and
Upper 6 mm values
are set to 100%.
The Upper 2 mm value
is set to 50%. The
remaining values are
set at 0%
1- 5 6
28. Repeat Steps 11 through 19, then skip to Step 28a.
a. If the curl is eliminated in both stacks of the output,
continue printing the job.
b. If the curl is eliminated in one stack but not the other,
additional adjustments are required; proceed to Step 29.
29. To reduce the remaining paper curl, fine tune the E Table
Settings by performing Steps 2-8 (in Step 4 select the same
Paper Type E1 through E6 as used previously), then Step 29a
a. If the 10 mm, 6 mm, and 2 mm values are 100%, reduce
the 2 mm value to 50%.
b. Do not change the other values.
KEY POINT: The above illustration is an example only. Your
actual E Table Settings for your print job may use different Upper/
Lower values than is shown above.
c. Repeat Steps 11 through 19, then skip to Step 28d.
d. If required, change these values:
2 mm = 25%
6 mm = 50%
e. Repeat Steps 11 through 19, then skip to Step 30.
30. If you are not successful in reducing the curl, call your Xerox
service representative.
D oc u Co l or 8 00 0/ 7 00 0 S y s te m A d mi n i s tr a ti o n G ui d e