Do c u Co lo r 80 0 0/ 70 0 0 S y s te m A dm i n is t r a ti o n G u id e
8. Exit the Tools Mode and run a few test prints to determine if
the curl was reduced to a satisfactory level.
•
If curl remains excessive, access Tools Mode, Decurler
Settings and repeat steps 3 through 8. Insure an alternate
Paper Type, selected from Paper Type A through Paper
Type D, has been selected each time these steps are
repeated.
9. Touch the Reset button on the Decurler Setup screen to return
to the settings established when you first accessed the screen.
•
If you are not successful in reducing the curl, go the Using
the Decurler E Table Settings procedure later in this
chapter.
1 . Too l s M od e
1-41