In this example, the
Upper 10 mm, 6 mm,
and 2 mm values are
changed to 100%. The
remaining values are
set at 0%.
Do c u Co lo r 80 0 0/ 70 0 0 S y s te m A dm i n is t r a ti o n G u id e
24. Repeat Steps 11 through 19 and then proceed to Step 24a.
a. If the curl is eliminated in both stacks of the output,
continue printing the job.
b. If the curl in both stacks is in the opposite direction from
the original paper curl, additional adjustments are required;
proceed to Step 25.
c. If the curl is eliminated in one stack but not the other,
additional adjustments are required; proceed to Step 29.
25. Perform Steps 2-8 (in Step 4 select the same Paper Type E1
through E6 as used previously) and then proceed with Step
26.
26. Set the values in the 10 mm, 6 mm, and 2 mm windows to
100%.
27. Set the remaining window values to 0%.
KEY POINT: The above illustration is an example only. Your
actual E Table Settings for your print job may use different Upper/
Lower values than is shown above.
1 . Too l s M od e
1-55