Viewing Basic Chassis Information; Hardware Information - Alcatel-Lucent OmniSwitch 6600 Family Hardware User's Manual

OmniSwitch 6600 Family Chassis and Hardware Components

Viewing Basic Chassis Information

This section covers the following basic chassis information and monitoring commands:
show hardware info
show module
show module long
show chassis
show cmm
show session xon-xoff
Important Hardware Status Commands. Additional commands, used to view important hardware status
information, are described earlier in this chapter:
For information on viewing primary and backup power supply status, refer to
•
For information on viewing chassis temperature status, refer to
•
For information on viewing chassis fan status, refer to
•

Hardware Information

To view basic hardware information about the switch, enter the
prompt. This command displays the following information:
CPU type
•
Flash and RAM memory information
•
NVRAM battery status
•
Jumper settings
•
BootROM and Miniboot versions
•
For example:
-> show hardware info
CPU Type
Flash Manufacturer
Flash size
RAM Manufacturer
RAM size
NVRAM Battery OK
Interrupt Boot Jumper
Force UART Defaults Jumper
Run Extended Memory Diags Jumper
Spare Jumper
BootROM Version
Backup Miniboot Version
Default Miniboot Version
OmniSwitch 6600 Family Hardware Users Guide
(and show ni)
September 2006
page
page 2-56.
show hardware info
: PowerPC 8245,
: SanDisk SDCFB-64
: 64094208 bytes (61 MB),
: Kingston,
: 134217728 bytes (128 MB),
: YES,
: OFF,
: ON,
: OFF,
: ON,
: 5.1.5.115.R02,
: 5.1.5.115.R02,
: 5.1.5.115.R02
Viewing Basic Chassis Information
page 2-34.
2-53.
command at the CLI
page 2-65