Managing Mac Addresses On The Switch; Mac Range Guidelines; Omniswitch 6600 Family Mac Range Specifications - Alcatel-Lucent OmniSwitch 6600 Family Hardware User's Manual

Omniswitch 6600 family
Table of Contents

Advertisement

OmniSwitch 6600 Family Chassis and Hardware Components

Managing MAC Addresses on the Switch

Your OmniSwitch 6600 Family switch is shipped with thirty-two factory-installed MAC addresses. These
MAC addresses, which are stored on an EEPROM card in the chassis, are used by the switch as unique
identifiers for the following functions:
Base chassis MAC address
802.1X authentication
VLAN router ports
Similar to IP addresses, MAC addresses are assigned by the Internet Assigned Numbers Authority (IANA)
and distributed to users in sequential blocks. A sequential block of MAC addresses is referred to as a
MAC address range.
The switch's EEPROM contains two factory-installed MAC address ranges:
MAC Range 1
MAC Range 3

MAC Range Guidelines

You cannot edit or delete MAC range 1 or MAC range 3 at any time.
The factory-installed 32 MAC addresses are sufficient for most network configurations. However, if
you require additional MAC addresses for your network, you may purchase additional MAC addresses
from Alcatel. Contact your Alcatel representative for more information.

OmniSwitch 6600 Family MAC Range Specifications

Number of Factory-installed MAC Ranges
Number of MAC Addresses in Default Range 1
Number of MAC Addresses in Default Range 3
Maximum MAC Ranges on Switch
Base chassis MAC address
Supported MAC Router Mode
OmniSwitch 6600 Family Hardware Users Guide
Reserved for the first two MAC addresses in the factory installed range of 32
MAC addresses. The first—or start—MAC address in this range is always
allocated as the base chassis MAC address. The second MAC address is
allocated for 802.1X authentication.
Contains MAC addresses used for each port in the system.
September 2006
Managing MAC Addresses on the Switch
2 (MAC Range 1; MAC Range 3)
2
30
2 (MAC Range 1; MAC Range 3)
Unique to each switch. The base
chassis MAC address is always the
first MAC address listed in the
switch's default MAC range 1.
Single
page 2-71

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents