Installing Sfps (Os6600-U24) - Alcatel-Lucent OmniSwitch 6600 Family Hardware User's Manual

OmniSwitch 6600 Family Chassis and Hardware Components

Installing SFPs (OS6600-U24)

OmniSwitch 6600-U24 switches support upto twenty-four 100 Mbps Small Form Pluggable (SFP)
modules. These SFPs are packaged separately and therefore are not factory-installed. You can install the
SFP(s) by following the steps below:
Anti-Static Warning. Before handling any component, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the SFP, as well as the switch and
uplink module.
1
Align the transceiver with the transceiver slot on the OS6600-U24 as shown.
Note. The SFP should slide in easily. Do not force the SFP into the slot. Otherwise you can damage the
connectors. If any resistance is encountered, ensure the SFP is aligned and oriented properly, as shown in
the diagram above.
2 Holding the SFP by its sides, carefully slide it into the desired SFP slot (ports 1–24) until it clicks into
place; this is an indication that the connectors are firmly seated.
OmniSwitch 6600 Family Hardware Users Guide
Inserting the SFP
September 2006
Installing SFPs (OS6600-U24)
page 2-51