Iii. Moving The Machine - Canon PC920 Service Manual

CHAPTER 9 INSTALLATION

III. MOVING THE MACHINE

If you need to move the machine by truck or any other means of transportation after installa-
tion, be sure to perform the following:
Caution:
Before starting the following work, check to make sure that the machines is not too hot. If it is, as
immediately after continuous copying, you may not be able to carry out step 8, in which the
shipping attachment is replaced.
Step
1
Turn on the power, and press the Default Ra-
tio key to select 70%.
2 Press the Paper Select key to select the manual
feed tray; then, press the Copy Start key with-
out placing any paper on the manual feed tray.
3 Turn off the power switch, and disconnect the
power plug from the outlet.
Pull the open/close lever found on the left of
4
the machine, and open the machine's top unit.
5 Take out the shipping attachments [1] and [2]
stored in the machine's bottom unit.
6 Detach the copy tray.
Press down on the
7
machine's top unit to fully close the machine.
9-12
Work
[2]
[1]
marking on the
COPYRIGHT © 1999 CANON INC.
Checks and remarks
The count/ratio indicator will indicate '
CANON PC800s/900s REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
'.