CHAPTER 11 TROUBLESHOOTING
e-2. Routing the Scanner Drive Cable
1. Before Starting the Work
Prepare the following:
• Mirror positioning tool (FY9-3009)
• Cable clip (FY9-3017)
• Adhesive tape
1) Set the mirror positioning tool as shown.
2) Prepare about five strips of adhesive tape (each one about 20 50 mm).
3) Remove the copyboard glass. (See Chapter 7.III.C.1."Removing the Copyboard Glass.")
4) Disconnect the connectors (J101, J131) [1] from the DC controller PCB.
11-12
Figure 11-213
[1]
Figure 11-214
COPYRIGHT © 1999 CANON INC.
CANON PC800s/900s REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)