Applying The Filter; Figure 8-6. Remote Node Profile Menu - NETGEAR RH348 Reference Manual

Reference Guide for the Model RT328 and Model RH348 ISDN Routers

Applying the Filter

When the filter design is finished, you must tell the router where to apply the filter. Apply it as a
Call Filter in the remote node that reaches your DNS server(s) (usually your ISP node). Go to
Menu 11.1, Remote Node Profile, and enter the number of the filter under "Call Filter Sets" as
shown in Figure 8-6. If you have multiple filters, you can cascade up to four by entering their
numbers separated by commas.
Figure 8-6 shows the Remote Node Profile Menu.
Rem Node Name= MyISP
Active= Yes
Call Direction= Outgoing
Incoming:
Rem Login=
Rem Password= ********
Rem CLID= N/A
Call Back= N/A
Outgoing:
My Login= netgear
My Password= ********
Authen= CHAP/PAP
Pri Phone #= 18005551212
Sec Phone #=
Press ENTER to Confirm or ESC to Cancel:
Figure 8-6. Remote Node Profile Menu
When you finish, restart the router.
8-14
Menu 11.1 - Remote Node Profile
Edit PPP Options= No
Rem IP Addr= 0.0.0.0
Edit IP= No
Telco Option:
Transfer Type= 64K
Allocated Budget(min)= 0
Period(hr)= 0
Session Options:
Input Filter Sets=
Output Filter Sets=
Call Filter Sets= 1
Idle Timeout(sec)= 300
<<- APPLY
Filter Configuration