This chapter contains information about configuring your Model RT328/RH348 router through
the built-in Manager interface.
Configuration Methods
If you are using a PC, you have the following two options to configure your router:
•
Through FirstGear
FirstGear is an easy-to-use Windows-based utility that leads you through a Quick Setup or
an Advanced menu for configuring your router. For FirstGear instructions, refer to Getting
Started Using FirstGear for the Model RT328 and Model RH348 ISDN Routers.
•
Through the built-in Manager interface
If you are using a Macintosh or UNIX-based workstation, the built-in Manager interface is the
only way that you can configure your router through your computer. However, you can use a
PC to configure the router and then connect the router to the Macintosh or workstation after the
configuration process is complete.
The built-in Manager interface is accessible through either a serial or a Telnet connection (refer to
"Connecting Through a Serial
respectively, of
Chapter 2, "Router Installation and
been assigned an IP address, you cannot connect through a Telnet session. You must use a serial
connection.
Router Configuration
Port" or
"Connecting Through a Telnet
Router Configuration
Connection" on
Connection"). If the router has not previously
Chapter 3
page
2-9,
3-1