Tcp/Ip Tools; Figure 9-2. Trace Display For A Successful Tcp/Ip Protocol Connection; Figure 9-3. Trace Display For A Failed Tcp/Ip Protocol Connection - NETGEAR RH348 Reference Manual

Figure 9-2 illustrates an example of a trace display for a successful call when using a TCP/IP
protocol connection.
Start dialing for node <1>
### Hit any key to continue.###
Dialing chan<2> phone(last 9—digit):40101
Call CONNECT speed<64000> chan<2> prot<1>
LCP up
CHAP send response
CHAP login to remote OK!
IPCP negotiation started
IPCP up
Figure 9-2. Trace Display for a Successful TCP/IP Protocol Connection
Figure 9-3 shows an example of a trace display for a failed call when using a TCP/IP protocol
connection.
Start dialing for node<1>
### Hit any key to continue.###
Dialing chan<2> phone(last 9–digit):40101
Call CONNECT speed<64000> chan<2> prot<1>
LCP up
CHAP send response
###Login to remote failed. Check name/passwd.
Receive Terminate REQ
LCP down
Line Down chan<2>
Figure 9-3. Trace Display for a Failed TCP/IP Protocol Connection

TCP/IP Tools

Enter 11 to select the Internet Setup Test. This test checks to see if your Internet access
configuration has been done correctly. The router dials the ISP, performs authentication, and
establishes a connection. If everything is working properly, you receive an appropriate response.
If you receive an error message, note the error message and consult your network administrator.
Enter 12 to select Ping Host. This diagnostic test pings a local or remote host. You are prompted
for the IP address of the host.
System Maintenance
Reference Guide for the Model RT328 and Model RH348 ISDN Routers
9-7