Other Settings; Remote Control Settings - Marantz NR1602 Owner's Manual

Other settings

Remote control settings

• When you connect a remote control receiver unit (purchased separately) to the REMOTE CONTROL IN
connector of this unit, use the following procedure to disable the remote sensor function of this unit.
• The remote sensor function of remote control signals is enabled by default.
ON/STANDBY
SURROUND MODE
n Disabling the sensor function of the remote control unit
When the main unit is in standby mode, press
SURROUND MODE and PURE DIRECT
"Remote Lock:ON" is shown on the display, and the infrared light receiving function is disabled.
n Enabling the remote sensor function
When the main unit is in standby mode, press
SURROUND MODE and PURE DIRECT
The infrared light receiving function on the main unit is enabled.
NOTE
If a remote control receiver unit (purchased separately) is not connected, do not perform this setting. If you
do, you will not be able to operate this unit using the remote control unit.
BD
PURE DIRECT
ON/STANDBY while holding down
on the main unit.
ON/STANDBY
while holding down
on the main unit.
105