Marantz NR1602 Owner's Manual page 100

Setting items
GUI NET/USB : Set the NET/USB screen display time when the input source
(Continued) is "NET/USB".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
iPod : Set the iPod screen display time when the input source is
"USB/iPod".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
Tuner : Set the tuner screen display time when the input source is
"TUNER".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
Zone Rename • Up to 10 characters can be input.
Change the display title of • For character input, see page 78.
each zone to one you prefer.
ON : Display is always on.
Display
Set the display on/off Auto OFF : Display is off except when showing the status display.
setting. OFF : Display is always off.
• This can also be set by pressing
DISP
Each time
ON
DISPLAY
• If on the main unit is pressed, the
same function as with the remote control unit
can be obtained.
BD
Setting details
DISP
.
is pressed, the setting is changed as shown below.
Auto Off
OFF
Setting items
Setup Lock ON : Turn protection on.
Protect settings from OFF : Turn protection off.
inadvertent change.
When canceling the setting, set "Setup Lock" to "OFF".
NOTE
When "Setup Lock" is set to "ON", the settings listed below can no
longer be changed. Also, "Setup Lock!" is displayed if you attempt to
operate related settings.
• Menu operations
• M-DAX
• HT-EQ
Firmware Update Check for Update : Check for firmware updates. You can also check
Update the firmware of the approximately how long it will take to complete an update.
receiver. Start : Execute the update process.
When updating starts, the power indicator becomes red and the menu
screen is shut down. The amount of update time which has elapsed is
displayed.
• If updating fails, the set automatically retries, but if updating is still not
possible, one of the messages shown below is displayed. If the display
reads as shown below, check the settings and network environment,
then update again.
Display
Updating fail
Login failed
Server is busy
Connection fail
Download fail
97
System Setup
Setting details
• Channel Level
• Dynamic Volume ®
• Display settings
Description
Updating failed.
Failure to log into server.
Server is busy. Wait a while then try again.
Failure in connecting to server.
Downloading of the firmware has failed.
vSee overleaf