Other Settings; Remote Control Settings; Switching The On-Screen Display Output Mode - Marantz NR1601 User Manual

ENGLISH ENGLISH DEUTSCH DEUTSCH

Other settings

Remote control settings

• When you connect a remote control receiver unit (purchased
separately) to the REMOTE CONTROL IN terminal of this unit, use
the following procedure to disable the remote sensor function of
this unit.
• The remote sensor function of remote control signals is enabled by
default.
SURROUND MODE ENTER
STATUS
o p
n Disabling the sensor function of the remote
control
1
To enable the remote signal sensor function, press
SURROUND MODE
and hold and
seconds.
"IR:< ENABLE >" is displayed.
2
Press o p to select "DISABLE".
3
ENTER
Press .
The sensor function of the remote control signal of this unit is
disabled.
54
FRANÇAIS FRANÇAIS ITALIANO ITALIANO ESPAÑOL ESPAÑOL
n Enabling the remote sensor function
1
To disable the remote signal sensor function, press
and hold SURROUND MODE
seconds.
"IR:< DISABLE >" is displayed.
2
Press o p to select "ENABLE".
3
Press ENTER
The sensor function of the remote control signal of this unit is
enabled.
NOTE
If a remote control receiver unit (purchased separately) is not
connected, do not perform this setting. If you do, you will not be able
to operate this unit using the remote control.
STATUS
for 3
NEDERLANDS NEDERLANDS SVENSKA SVENSKA
and STATUS for 3
.
Switching the on-screen display
output mode
Set whether the menu is operated by the monitor connected to the
VIDEO OUT terminal or the monitor connected to the COMPONENT
VIDEO MONITOR OUT terminal.
• The factory setting is "Comp".
ENTER PURE DIRECT
STATUS
u i
1
Press and hold STATUS and PURE DIRECT for 3
seconds.
Corresponding to the video signal format settings,
"OSD Out: 0 Comp 1" or "OSD Out: 0Video 1" is shown
in the display.
2
Press u i to change the settings according to the
connection method.
Set when the COMPONENT VIDEO MONITOR OUT
Comp
connector is connected to a TV.
Set when the VIDEO OUT connector is connected
Video
to a TV.
3
Press ENTER to enter the setting.
NOTE
When operating the on-screen display menu using the monitor
connected to the HDMI OUT terminal, either setting may be used
without problem.