Table of Contents
Advertisement
Online spare population
For online spare memory mode configurations, observe the following guidelines:
•
Observe the general DIMM slot population guidelines (on page 50).
•
Each channel must have a valid online spare configuration.
•
Each channel can have a different valid online spare configuration.
•
Each populated channel must have a spare rank:
A single dual-rank DIMM is not a valid configuration.
o
LRDIMMs are treated as dual-rank DIMMs.
o
Lockstep Memory population guidelines
For Lockstep memory mode configurations, observe the following guidelines:
•
Observe the general DIMM slot population guidelines (on page 50).
•
DIMM configuration on all channels of a processor must be identical.
•
In multi-processor configurations, each processor must have a valid Lockstep Memory configuration.
•
In multi-processor configurations, each processor may have a different valid Lockstep Memory
configuration.
Population order
For memory configurations with a single processor or multiple processors, populate the DIMM slots in the
following order:
•
LRDIMM: Sequentially in alphabetical order (A through L)
•
RDIMM: Sequentially in alphabetical order (A through L)
•
UDIMM: A through H, sequentially in alphabetical order. Do not populate DIMM slots I through L.
After installing the DIMMs, use RBSU to configure Advanced ECC, online spare, or lockstep memory support.
Installing a DIMM
The server supports up to 24 DIMMs. To install a DIMM:
Power down the server (on page 21).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 21).
3.
Remove the access panel (on page 22).
4.
Remove the air baffle (on page 29).
5.
Open the DIMM slot latches.
6.
Hardware options installation 51
Advertisement
Table of Contents
