HP ProLiant DL360p Reference Manual page 94

Error code Error message
Failure opening capture file <text>
2866
Failure opening input file <text>
2867
Failure opening error file <text>
2868
There are no suitable spares available
2877
Invalid Physical Disk Type Specified
2880
Invalid MNP delay
2882
Invalid Option
3000
Command Failed
3002
License Key Delete Failed
3003
Invalid Sector Size
3004
Cannot delete Array
3005
Invalid Number of Parity Groups
3006
Chassis name is too long
3007
Chassis name is already in use
3008
Auto Configure failed
3009
Cannot extend logical drive, not enough
3010
free space for the requested size
Cannot extend logical drive, requested size
3011
is too small
Cannot specify both SIZE and SHRINKSIZE The input file cannot specify both a SIZE and
3012
Cannot shrink Array
3013
Cannot move Array
3014
Invalid operation - Advanced Pack support
3015
required
Spare drives cannot be specified by a count
3016
in Reconfigure mode
Disk drives cannot be specified by a count in
3017
Reconfigure mode
Invalid number of physical disks
3018
Cannot create Array - no physical disks
3019
specified
SSP must be enabled in order to perform this
3020
operation
Invalid connection name
3021
Comment or clarification
slot for an available, active controller, or the
controller is not available.
—
—
—
ACU found no drives that could be used as spares
for the specified array.
—
The specified value for MNP delay is invalid.
The value of the option supplied to this parameter is
invalid.
The controller returned an error for a command.
ACU is unable to delete the license key.
—
—
—
—
Another controller is already using the entered
chassis name.
The Auto Configure mode was unable to complete
auto configuration.
—
—
SHRINKSIZE parameter.
The array shrink operation was not successful.
The array move operation was not successful.
The requested operation requires a valid license key
to be entered.
When in Reconfigure mode, the requested spare
drives must be specified by their addresses. A simple
count cannot be used.
When in Reconfigure mode, the requested data
drives must be specified by their addresses. A simple
count cannot be used.
—
ACU cannot create an array unless physical disks
are specified in the input file DRIVE parameter.
For the specified operation, ACU requires SSP to be
supported and enabled.
—
HP Array Configuration Utility 94