HP ProLiant DL360p Reference Manual page 93

Error code Error message
New Logical Drive ID does not match the
2836
next available logical drive ID.
If you are attempting to replicate a
configuration that has non-consecutive
logical drive numbers, then you must
change the script file so that the logical drive
numbers are consecutive.
New Logical Drive ID already exists
2837
Cannot create Logical Drive
2838
Cannot migrate Logical Drive RAID
2839
Cannot extend Logical Drive
2841
Invalid RAID
2842
Invalid Size
2843
Invalid Stripe Size
2844
Invalid ClearConfigurationWithDataLoss
2849
parameter
Controller does not support Chassis Name
2850
Invalid Chassis Name
2851
Invalid SSP State
2852
Cannot change SSP settings
2853
Invalid SSP Adapter ID
2854
Invalid Surface Scan Delay
2857
Controller does not support redundancy
2861
settings
Invalid Preferred Path Mode
2864
Invalid Preferred Path
2865
Comment or clarification
The script file specifies a logical drive ID that is not
the first unused ID in the sequence. For example, this
message appears if the controller has only Logical
Drive 1 and the script file specifies creation of
Logical Drive 3 (omitting Logical Drive 2). A common
cause of this error is that the input file specifies
nonsequential logical drive numbers. In this case,
change the logical drive numbers in the input file so
that they are sequential.
This error occurs in Configure mode when the logical
drive ID specified in the script file already exists in
the configuration. In Configure mode, you can
create new logical drives only.
The array has no free space, or the maximum
number of logical drives has been reached already.
The controller does not support RAID migration, or
migration is not possible with the current controller
configuration.
The controller does not support extension, or the
current controller configuration cannot be extended.
For example, extension is not possible if the array
has no free space.
The specified RAID level is invalid or is not possible
with the current physical disk and array
configuration.
The specified size is invalid or is not possible with the
current configuration.
The specified stripe size is invalid, not supported by
the current RAID level, or not possible with the
current configuration.
The valid parameters are Yes and No (default).
The controller does not support setting a chassis
name.
The entered chassis name is invalid. Use characters
from the set a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +,
:, ., /, and [space]. The name cannot end with a
space character or exceed the maximum number of
characters allowed by the controller.
The requested SSP state is not a valid SSP state.
The SSP settings cannot be changed for the controller
or logical drive.
The adapter ID is not a valid adapter ID that was
detected by the controller.
—
The controller is not redundant or does not support
redundancy settings.
The specified value for the preferred path mode is
not valid, or the controller is not available.
The specified preferred path is not a valid chassis
HP Array Configuration Utility 93