Table of Contents
Advertisement
What to do if ...
The appliance cannot be
switched on or is not operat-
ing
The residual heat indicator is
not displaying anything
The automatic warm up func-
tion is not switching itself on
Acoustic signal sounds repeat-
edly, appliance switches off
Acoustic signal sounds when
appliance is switched off
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic sig-
nal sounds
Display is switching between
two heat settings
Problem
More than 10 seconds have
passed since the appliance was
switched on
The lock is switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
STOP+GO is activated
The cooking zone was only on
for a short time and is there-
fore not hot
There is still residual heat on
the cooking zone
The highest heat setting is set The highest heat setting has
One or more sensor fields have
been covered for longer than
10 seconds
The control panel is wholly or
partly covered by objects.
The On/Off sensor field has
been covered up, e.g. by a
cloth
Power management is reduc-
ing the power of this cooking
zone
Possible cause
What to do if ...
Remedy
Switch the appliance on again.
Switch off the lock (See the
section "Locking/unlocking the
control panel")
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
Switching off STOP+GO
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
Let the cooking zone cool
down
the same power as the auto-
matic warm up function
Uncover sensor field
Remove objects.
Do not place any objects on
the control panel
See the section "Switching the
power function on and off"
25
Advertisement
Table of Contents
