Table of Contents
Advertisement
Removable Frontline strip
The aluminium Frontline strip fastens on by means of magnets. It is
easy to remove by hand and can be cleaned with detergent. Please do
not use any scouring agents or sponges that scratch. Do not clean the
strip in the dishwasher.
What to do if ...
Problem
The cooking zones will not
switch on or are not func-
tioning
The residual heat indicator
is not displaying anything
Power function cannot be
switched on
Display changes between
two heat settings
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety device is
l
switched on
Several sensor fields were
touched at the same time
The sensor fields are partly
covered by a damp cloth or
with liquid
Safety cut-out has been
triggered
STOP+GO is activated
The cooking zone was only
on for a short time and is
therefore not hot
The Power function has al-
ready been activated sev-
eral times repeatedly in
quick succession
Power Management is re-
ducing the power of this
cooking zone
Remedy
Switch the appliance on
again.
Deactivate the child safety
device (See the section
"Child safety device")
Only touch one sensor field
Remove the cloth or the
liquid.
Switch the appliance on
again.
Switch the appliance on
again
Switching off STOP+GO
If the cooking zone is sup-
posed to be hot, call your
local Service Force Centre.
Let the cooking surface
cool down.
See section "Power Man-
agement" in the chapter
Operating the Appliance
21
Advertisement
Table of Contents
