What To Do If - Electrolux EHS601210P User Manual

What to do if ...

Problem
The cooking zones cannot be
switched on or are not operat-
ing
Acoustic signal sounds when
appliance is switched off
The residual heat indicator is
not displaying anything
The signal sounds and the ap-
pliance turns itself on, then off
again after 5 seconds. After
another 5 seconds the signal
sounds again.
lights up
and a number is displayed Electronics fault
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch-off has been
triggered
There is water on the control
panel or the control panel is
covered with fat splashes
The control panel is wholly or
partly covered by objects.
There is water on the control
panel or the control panel is
covered with fat splashes
The cooking zone was only on
for a short time and is therefore
not hot
Something is covering the On/
Off sensor field
Automatic switch-off has been
triggered
Get other manuals https://www.bkmanuals.com
what to do if ... electrolux 27
Remedy
Switch the appliance on again.
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch ap-
pliance on again
Wipe the control panel
Remove objects.
Wipe the control panel
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
Do not put any objects on the
control panel
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect appliance from the
electrical supply for a few min-
utes. (Take the fuse out of the
house's wiring system.)
If you still see and a number
after switching the appliance
back on, call the Customer
Service Department