Maintenance And Care 10; Glass Top; Burner Caps & Crowns; What To Do If - Electrolux EHG8321BC Installation & User Manual

Glass top

•Persistent stains may require vigorous rubbing with nylon
scourer or creamed powder cleansers. Household enamel
cleaners are available, follow the manufacturer instructions
in their use. Harsh abrasive cleaners, powder cleaners,
steel wool or wax polishes should not be used.
•Do not use the glass top as a work table.
Burner caps & crowns
•These can all be lifted off and removed for separate
cleaning.
•Ensure burner caps and crowns are thoroughly dried after
cleaning or spillage.
•When cleaning the burner, ensure that all the flame ports,
injector hole and other holes are free of any blockage.
(Fig 13,14)

What to do if

Phenomenon
Burner will not light...
By directly heat more efficiently, our FlameShield Trivet cook tops cook faster and consumer less energy
than previous models, helping you to achieve quick, tasty meals, whilst also lowering your energy bills
Burner lights back to injector...
over time.
Burner has explosive ignition...
lgnitor not sparking...
WARNING:
Do not spray aerosols in the vicinity of this hob while in operation. Some propellant gases can break down when
heated and produce corrosive vapours which will attack some materials.
Articles which are made from flammable materials should not be stored in drawers or cupboards immediately below
this hob.
Do not store articles within 50mm of the base.
Do not touch spark ignitor while lighting the burner.
Where this appliance is installed in a marine craft or in caravans, it shall not be used as a space heater.
•After cleaning, ensure the burner caps are
reassembled properly into position.
•After cleaning service, when assembling the burner
crown and caps, care must be taken to ensure the spark
plug is not knocked. The spark plug will crack if knocked
and may face risk with flame ignition problem.
Reason
Air in gas line
Blockage in line
Ignition not sparking
Battery is flat
Burner not fitted correctly
Excessive lint up of burner
Excessive gas pressure
Excessive gas pressure
Excessive electrode gap
lgnitor connections loose
Battery is flat

maintenance and care 10

Solution
Purge gas line
Trace
Check
Replace
Fit burner in
mixing tube Remove
Check gas regulator pressure
adjust
Check gas regulator pressure
adjust if
Check gap, and adjust so it is
4-5mm
Check connections to
replace
Change
back clear
&
lead & electrode
battery
correct position
clean burner
&
&
if necessary
&
necessary
ignitor,
if faulty
a new battery