What To Do If - Electrolux EHD 68200 P User Manual

What to do if ...

Problem
The appliance cannot be
switched on or is not operating
The residual heat indicator is
not displaying anything
The automatic warm up func-
tion is not switching itself on
Sensor fields are getting hot
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds when
appliance is switched off
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5 sec-
onds another acoustic signal
sounds
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The lock is switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
The cooking zone was only on
for a short time and is therefore
not hot
There is still residual heat on
the cooking zone
The highest heat setting is set The highest heat setting has
Cookware too big or placed
too near the controls
One or more sensor fields
have been covered for longer
than 10 seconds
The control panel is wholly or
partly covered by objects.
The On/Off sensor field has
been covered up, e.g. by a
cloth
what to do if ... electrolux 27
Remedy
Switch the appliance on again.
Switch off the lock (See the
section "Locking/unlocking
the control panel")
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
Let the cooking zone cool
down
the same power as the auto-
matic warm up function
Place cookware in the middle
on one of the four cooking
zoznes. Place large cookware
on the back cooking zones in
preference.
Uncover sensor field
Remove objects.
Do not place any objects on
the control panel