Basic Data Settings; Modifying Set Parameters - Electrolux Air-O-Speed AOW101E Installation And Operation Instruction Manual

1) Press the PROGRAM button:
2) Select the required program and press the button P2 (
to confirm. To cancel, just return to PROGRAM mode.
3) Press the START/STOP button to start the selected program.
To exit, modify or skip phase, refer to the sections on manual
control (MANUAL).
5. SETTINGS BASIC DATA
To set or display the Basic Data, proceed as follows:
1) Switch the oven on by pressing the button I (O - I).
2) Press the button P4.
SETTINGS
_________________________________________________________
LANGUAGE
COMMUNICATION
CHANGE PASSWORD
OVEN STATUS
________________________________________________________ ________________________________________________________ ________________________________________________________ ________________________________________________________ ________________________________________________________
- TIME AND DATE -
• Press the button P3 (
________________________________________________________
TIME
MINUTES
DAY
MONTH
YEAR
FORMAT TIME
________________________________________________________
* 24h (hours) or
AM/PM (AM = Ante Meridiem) (PM = Post Meridiem)
4) turn knob K to increase or decrease the value
(e.g. 8:00 selected, in the morning AM of September 14 2005)
CLOCK
) to enter the CLOCK page.
CLOCK
AM * 08
40
14
09
05
AM/PM *
5) press the button P2 (
(going from hours to minutes)
Note:
To display the time, press the button P1 (
) inactive.
- LANGUAGE -
• Press the button P2 (
P3 ( ) to confirm.
• Press the button P2 (
and P3 ( ) to confirm it (some languages are on the next page,
therefore continue after the last item on the list to change page).
________________________________________________________
ENGLISH
ITALIANO
DEUTSH
................
.....................
..........................
________________________________________________________
ENGLISH is selected in the example.
• Press the button P4 (

6. MODIFYING SET PARAMETERS

With the cooking cycle stopped , started or stored, operate the
relevant controls to modify the following parameters:
MANUAL
1) cooking mode;
2) cooking temperature
3) cooking time ;
4) core probe temperature
AUTOMATIC
1) Cooking level.
Note:
- When modifying the parameters of a STORED program the new
memorization will delete the previous one.
To modify the next phase during the cooking cycle with several
phases, the following operations must be carried out:
a) Press the START/STOP button to stop the cooking cycle in
progress.
b) Press the button P2 (
evant phase, modify the required values, setting them again.
c) Press the START/STOP button to resume the cycle in progress.
31
) to select the other data to be modified
) when the oven is
) to select the item LANGUAGE and
) again to select the required language
LANGUAGE
<<<<
) to exit.
;
(alternatively to cooking time).
) and turn knob K to display the rel-
EN