Electrolux Air-O-Speed AOW101E Installation And Operation Instruction Manual page 27

The oven is equipped with a MULTIPOINT core probe with 6 sen-
sors along the entire stem, for correctly measuring the product
core temperature even if the tip is not completely in the center.
- Close the door and press the button P3 (
5) Stopping the cycle. When the required product core tem-
perature is reached the oven stops automatically with the
previously described procedure (refer to par. 4.3.7 STOPPING
OF COOKING CYCLE) and the elapsed cooking cycle time is
shown in a special window (POP-UP).
6) Core probe mode deactivation.(Operationis only possible
with cooking cycle stopped). Set a cooking time on the Timer
This action automatically cuts out the core probe, whereas the op-
posite occurs when the time is set.
Core probe mode is also deactivated when the oven is switched
off.
4.4.5 SETTING COOKING HUMIDITY
(Only in CONVECTION, COMBI and REGENERATION
cooking modes)
Important
When the oven is switched on after several hours of inactivity,
wait 20 seconds (the time necessary for stabilization of the
LAMBDA probe) for a correct HUMIDITY reading.
After selecting CONVECTION, COMBI or REGENERATION cook-
ing mode, press the button P2 to select the % HUMIDITY field and
set it as required with knob K.
E.g.
SET COMPARTMENT________________
HUMIDITY 75%
CURRENT HUMIDITY___________ I
is displayed by the colored zone of the % field (blue 50%)
4.4.6 MICROWAVE SETTING
1) Press the button P2 ( ) several times to select the MICRO-
WAVE field and set the required microwave power (500W every
level square) with knob K.
E.g.
SET MICROWAVE__________________
POWER 1500W
4.4.7 STARTING COOKING CYCLE - MANUAL
- make sure the oven door is closed;
- Press the START/STOP button (the message PREHEAT ap-
pears)
Preheating is automatic for any set cooking cycle; to skip it press
the button P3 ( ) or go to the next point.
- Wait until the compartment temperature field indicates the reach-
);
.
I
I
ing of preheating temperature (the message LOAD appears)
- Open the door and introduce the product to be cooked.
Caution! Risk of burns.
Always open the door with caution when the oven is hot.
- Close the door and press the button P3 (
The GRAPHIC DISPLAY shows the COOKING IN PROGRESS
screen, giving the following information:
DISPLAY OF SET PARAMETERS
recipe or program ________________________
phase___________________________
cooking mode____________________
set humidity (100%)____________________
________
__________________
set temperature (300°F)
____________
microwave quantity
___________________________________
set
utility
set temperature _____________________________ I
DISPLAY OF CURRENT PARAMETERS
To see the CURRENT cooking parameters(displayed in a special
POP-UP window) press the buttonP1 (
___________________
total remaining time
(58 minutes)*
HUMIDITY 90%
COMPARTMENT
TEMPERATURE 126°F
Time _______DURATION
elapsed COOKING
CORE PROBE
TEMPERATURE 75°F
CURRENT PARAMETERS
_______________
current temperature
(80°F "27°C")
(*) The time remaining for the end of the entire cycle, 58 minutes
in this case. In fact, the countdown for the cooking time is carried
out.
27
);
I
I
I
100
300
1 : 00
(timed setting)
149
80
(setting with core probe)
).
100
300
0 : 58
1: 00
______
P1
(timed setting)
149
80
(setting with core probe)
EN