HP D6030A - NetServer - E50 User Manual page 58

Chapter 5
Code Description
0509h DiagTools Error
050Ah DiagTools Error
050Bh DiagTools Error
050Ch DiagTools Error
050Dh DiagTools Error
050Eh DiagTools Error
050Fh DiagTools Error
0510h No Tape in unit.
0511h Positioning failed on
tape drive.
0512h DiagTools Error
54
Recommended Action
4. Check for proper termination, using technical reference card or label.
5. Check system fans
6. Check firmware version of drive and update if necessary.
7. Replace the drive
8. Change the card or board that has the drive's controller.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
Download a new version of DiagTools from the HP web site and run it. If you
get the same error, call the HP Customer Care Center.
1. Use a cleaning cartridge to make sure heads are clean.
2. Replace the tape.
3. Check cables and connections: a) to SCSI components, b) to power source, c)
between cards and backplane.
4. Inspect SCSI pins to ensure none are bent.
5. Check seating of board or SCSI card.
6. Check for proper termination, using technical reference card or label.
7. Check system fans
8. Check firmware version of drive and update if necessary.
9. Replace the drive
10. Change the card or board that has the drive's controller.
1. Use a cleaning cartridge to make sure heads are clean.
2. Replace the tape.
3. Check cables and connections: a) to SCSI components, b) to power source, c)
between cards and backplane.
4. Inspect SCSI pins to ensure none are bent.
5. Check seating of board or SCSI card.
6. Check for proper termination, using technical reference card or label.
7. Check system fans
8. Check firmware version of drive and update if necessary.
9. Replace the drive
10. Change the card or board that has the drive's controller.
Download a new version of DiagTools from the HP web site and run it. If you
Error Message Reference