Rack Mount Kit - HP StorageWorks 2/16 - SAN Switch Installation Manual

Installing the Switch in a Rack Using the SAN Switch Universal

Rack Mount Kit

This section provides instructions for installing the SAN Switch 2/32, SAN
Switch 2/16, or SAN Switch 2/8 in an HP System/e rack, or in an HP 9000 Series
or comparable EIA rack using the SAN Switch Universal Rack Mount Kit, part
number 331148-B21.
Figure 1: SAN Switch 2/16 rack-mounted switch
Note:
The following items are required to install the switch in a rack:
HP StorageWorks SAN Switch 2/8|16|32 Installation Guide
Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit
The Universal Rack Mount Kit installation requires two technicians.
SAN Switch 2/32, SAN Switch 2/16, or SAN Switch 2/8
Power cables
#2 Phillips screwdriver
7/16-inch wrench or socket
The SAN Switch Universal Rack Mount Kit rails and rail mounting hardware
listed below:
(2) Rear mounting brackets
1
Addendum Pg