HP StorageWorks 2/16 - SAN Switch Installation Manual page 8

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit
Figure 5: Assembling the outer rails (HP 9000 Series or comparable EIA rack)
6
Addendum Pg
b. Depending on the rack you are using, complete one of the following tasks:
— For an HP 9000 Series or comparable EIA rack, install two #10-32 x
1/2-inch Phillips pan-head screws with captive star lock washers and two
#10 adapter washers in the upper and lower hole locations of the right rail.
Then install two #10-32 x 1/2-inch Phillips pan-head screws with captive
star lock washers and two #10 adapter washers in the upper and lower
hole locations of the left rail. See Figure 5.
HP StorageWorks SAN Switch 2/8|16|32 Installation Guide