HP StorageWorks 2/16 - SAN Switch Installation Manual page 9

Figure 6: Assembling the outer rails (HP System/e rack)
5. Determine the number of #8-32 x 3/16-inch Phillips pan-head screws with
Table 1: Number of screws required to assemble the inner rails
HP StorageWorks SAN Switch 2/8|16|32 Installation Guide
Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit
— For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head
screws with captive star lock washers and two #10 alignment washers in
the upper and lower hole locations of the right rail. Then install two
#10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers
and two #10 alignment washers in the upper and lower hole locations of
the left rail. See
captive star lock washers required to assemble the inner rails by referring to
Table 1.
Switch
SAN Switch 2/32
SAN Switch 2/16
SAN Switch 2/8
Figure 6.
Number of #8-32 x 3/16-inch
Screws
12
10
14
Addendum Pg
7