Attaching The Mounting Hardware To The Director 2/140 - HP StorageWorks 2/140 - Director Switch Installation Instructions Manual

Installation Instructions

Attaching the Mounting Hardware to the Director 2/140

Use these steps to secure the mounting hardware to the Director 2/140.
NOTE: All mounting brackets are attached to the Director 2/140 using 10/32 x 3/8-inch flathead
countersunk Phillips screws.
1. Locate the two front mounting brackets in the shipping carton.
2. Secure the front mounting brackets on either side of the Director, as shown in
Figure 4. For each front mounting bracket, use three screws.
Figure 4: .Securing the front mounting brackets to the Director 2/140
3. Locate the two rear mounting plates in the shipping carton.
4. Secure the two rear mounting plates to each side of the Director, as shown in
Figure 4. For each plate, use three screws.
8 director 2/140 rack mount kit installation instructions