HP StorageWorks 2/140 - Director Switch Installation Instructions Manual page 15

3. Use a straight edge to locate the corresponding rack hole along the interior vertical
rails of the rack cabinet. Mark this location on each interior vertical rail.
4. Position a small angle bracket along the interior vertical rail as shown in Figure 2.
Align the angle bracket so that the two threaded holes on the small tab align with
the 1U location marked in
5. Secure the angle bracket to the rail using two self-tapping sheet metal screws.
6. Repeat step 2
vertical rail of the cabinet.
Figure 2: Angle brackets mounted on vertical cabinet rails in HP 9000, 10000
and 11000 series rack
director 2/140 rack mount kit installation instructions
step 3.
through step 5 to mount a small angle bracket on each interior
Installation Instructions
5