Fax Automatic Reception - Kyocera TASKalfa 8000i Operation Manual

FAX Automatic Reception

When using this machine as a FAX-dedicated machine that does not receive telephone calls, set the machine
to FAX-dedicated reception. No special operation is required when receiving faxes.
NOTE:
When you are receiving DRD service from a telephone company, change the reception method to
[Auto (DRD)]. For details, refer to DRD Reception (Available for inch versions only) on page 6-19.
Reception Method
This machine allows the following five reception methods.
• Auto (Normal)
• Auto (FAX/TEL) (Refer to page 6-7.)
• Auto (TAD) (Refer to page 6-9.)
• Auto (DRD) (Refer to page 6-19.)
• Manual (Refer to page 4-14.)
Checking and Changing the Reception Method
Reception Starts
Memory Reception
1
Press the System Menu key.
2
Press [FAX], [Next] of Reception, [Next] of FAX,
and then [Change] of RX Setting.
3
Select [Auto (Normal)].
4
Press [OK].
1
When a fax has been sent to you, the machine
rings the registered number of times, and then
starts receiving the fax.
After reception has started, the Processing
indicator blinks.
NOTE:
You can change the number of times the
ringing tone rings. (Refer to Rings on page 6-11.)
To cancel the reception, refer to Cancelling
Transmission (Disconnection of Communication) on
page 3-15.
When the machine cannot print a fax due to paper
running out or a paper jams, it temporarily stores
originals that have been sent in the image memory.
When the machine returns to the printable state,
printing starts.
3-12
FAX Operation (Basic)