Iii-7-3. Dhcp Server - Edimax EW-7228APn User Manual

Click "APPLY" to save changes. The following message will appear:
Click "CONTINUE" to save the changes but not apply them yet. This allows you
to make further changes in the browser-based management interface, before
applying them all at once.
Click "APPLY" to restart the device and implement any changes. The device will
restart itself.
III-7-3. DHCP Server
The access point can be configured to act as a DHCP server for your network.
By default DHCP is disabled.
Enter the appropriate information as shown below.
Note: To reset the IP address back to its
default value of 192.168.2.1, press and hold
the WPS/Reset button on the access point
for 10 seconds. Be aware that doing so
restores all settings and passwords back to
factory defaults.
Note: This option will be unavailable unless
you enable this function by selecting
"Enabled" from the drop down menu
labeled "DHCP Server", under the heading
"Management IP" as detailed above
61