Table of Contents
Advertisement
Changing the Tuner Settings (Tuner Out)
Turn on the Tuner.
1.
Move the cursor to OUTPUT.
2.
Select the output while Tuner is on.
3.
Value
Explanation
Sounds input to the GT-10B bypass the processing
Bypass
and are output directly as is.
Mute
Sounds are muted, and no sound is output.
Switching the Tuner On and Off with the CTL Pedal
By setting the CTL Pedal function (p. 48) to "Tuner," you can switch the tuner on and off with one of the CTL pedals.
Switching the Tuner On and Off by Lifting Up on the EXP Pedal
When the EXP Pedal is functioning as a Foot Volume control, set one of the ASSIGN 1–8 Assign Variable settings (p. 51) as
follows.
With these setting, you can switch on the Tuner by drawing back the EXP Pedal.
Target:
Tuner Sw
Min:
On
Off
Max:
Source:
EXP1 PEDAL
Switching the Tuner On and Off with the Number Pedal
Set the Num Pdl Sw function (p. 58) to Tuner to switch the tuner on and off with the number pedal of the current patch.
Src Mode:
Moment
ActRngLo:
0
1
ActRngHi:
Chapter 1 Outputting Sounds
• When OUTPUT is set to "Bypass," and Tuner
is set to ON, you can adjust the volume of the
direct sound by operating the EXP Pedal.
• OUTPUT is set to "Bypass" when shipped
from the factory.
Off
FX
Effector
On
Mute
Bypass
TUNER
EXP
TUNER
Pedal
OUTPUT
TUNER
Switch
29
Advertisement
Table of Contents
