Ch.select (Channel Select) - Boss GT-10B Owner's Manual

CH.SELECT (Channel Select)

Ch.Mode (Channel Mode)
Selects how the two channels are to be used.
Only the channel selected with [CHAN-
NEL SELECT] or Ch.Select is used.
Single
The output of Channels A and B is mixed.
Dual Mix
Channel A is output from the left and
Channel B is output from the right.
Dual L/R
The low-frequency range is assigned to
Channel A, and the high-frequency range
is assigned to Channel B.
Low-frequency
Freq Divide
Range
High-frequency
Range
Channels A and B are switched according
to the bass input volume level.
The GT-10B switches to Channel B when
the strings are picked with greater force.
This produces dynamic tonal changes in
response to the picking dynamics.
Dynamic SW
Channel A's volume level is controlled
Dynamic A according to the bass input volume level.
The volume in Channel B is fixed.
Channel B's volume level is controlled ac-
Dynamic B cording to the bass input volume level.
The volume in Channel A is fixed.
Ch.Select (Channel Select)
These switch between the A and B chan-
Ch.A, Ch.B
nels for the effect.
Ch.A Lev/Ch.B Lev (Channel A Level/Channel B
Level)
0–100 Adjusts the volume of the each channels.
Xover f (Crossover Frequency) *1
This sets the frequency dividing the low-
100Hz–4.00kHz
and high-frequency ranges.
A
B
A
B
A
L
R
B
A
B
A
B
Detect
Input Level
Chapter 8 Parameters Guide
Sens (Sensitivity) *2
When the Ch.Mode parameter is set to
Dynamic Sw, raising the value allows
switching of the channels even with
weaker picking.
0–100 When the Ch.Mode parameter is set to
Dynamic A (or Dynamic B), raising the
value enables volume level changes in
Channel A (or Channel B) even with
weaker picking.
Release *2
This adjust the rate of the response when
0–100
the input level drops.
*1 This setting value is enabled when the Ch.Mode parameter is set
to Freq Divide.
*2 This setting value is enabled when the Ch.Mode parameter is set
to Dynamic Sw, Dynamic A, or Dynamic B.
133