Table of Contents
Advertisement
Example of Setting the Pedal Function
Setting the parameters as shown below in the EXP1 PEDAL SETTING screen enables you to constantly use the GT-10B's
EXP Pedal as a wah pedal.
Prefernc:
System
Function:
WAH
Min:
0
Max:
100
Setting CTL/EXP Functions Individually in Each Patch (PEDAL FX)
This procedure sets the functions for the GT-10B's controllers (CTL/EXP Pedal, EXP PEDAL SW) for individual patches.
* Set the Prefernc parameter of the CTL/EXP Pedal and EXP PEDAL SW (p. 137) settings to "Patch."
1.
The MST/PDL FX screen appears.
Select PEDAL/FX.
2.
The PDL:CTL/EXP screen appears.
3.
4.
P1: CTL1 Pedal
P2: CTL2 Pedal
P3: EXP PEDAL SW
P4: EXP Pedal
5. To save the settings, use the Write procedure (p. 43).
Make the parameter settings.
Chapter 4 Playing Sounds
Pressing [DISPLAY MODE] toggles the display between Knob View and
List View.
• Some EXP Pedal parameters use multiple pages for the parameter
settings. You can use [
] or [
• Each time [MASTER/PEDAL FX] is pressed, the EXP Pedal functions
alternate as shown below.
Parameter
Functions Switched
Normal Foot Volume
Foot Volume
(Does not include an ON/OFF
switching function)
Pedal Bend
Pedal Bend On/Off
WAH
Wah On/Off
PB/FV
Pedal Bend, Foot Volume
WAH/FV
Wah, Foot Volume
The currently selected setting is the one highlighted at the
lower right of the display.
For information on what settings you can assign, refer to "SW&PDL
FUNCTION" (p. 122).
] to switch pages.
49
Advertisement
Table of Contents
