14. In the "Value" field, enter a multicast IP address and a port number for the Paging key. When
you press this key, the phone initiates an outgoing multicast RTP session to the specified
address using the specified port. (For example, 239.0.1.15:10000).
15. To receive RTP steams for Group Paging, you must also configure the "Paging Listen
Addresses" parameter at the path, Basic Settings->Preferences->Group Paging RTP Settings.
For more information about setting this parameter, see
streams)"
16. Click
Using the Paging Key
The following procedure describes the use of the Paging key on the IP Phone. The procedure
assumes you have already configured the Paging key using the Aastra Web UI.
1. On the IP Phone, press the softkey, programmable key, or expansion module key you
configured for Paging (labeled as "Group 1" in the following illustration).
Model 6755i IP Phone User Guide
Notes:
1. When you select Paging for the "Type" field, the "Line" field is disabled.
2. The "Value" field allows for one multicast address entry only.
on
page
235.
to save your changes
IP Phone UI
Notes:
1. Recipient of a Paging call can set a global "Do Not Disturb" (DND) to ignore
any incoming pages.
2. For incoming Paging, the phone uses the Intercom configuration settings. The
incoming Page is dependant on the "Allow Barge-In" parameter setting and the
"Idling/On Call" state.
Services
Icom
Dir
Callers
Tues Jan1 10:00am
Group 1
LAB
ACD
"Group RTP Paging (receives RTP
145