Connector Description - Supermicro Supero X8DTU-F User Manual

Jumper Description
JBT1 CMOS Clear
JI C1/JI C2 SMB to PCI-Exp. Slots
2 2
JPG1 VGA Enable
JPL1 LAN1/2 Enable
JWD Watch Dog
Connector
COM1/COM2
FAN 1-8
IPMB
JD1
JF1
JL1
JOH1
JPI C
2
JPW1
JPW2/JPW3
JUIDB
LAN1/2
IPMI_LAN
I-SATA0 ~ I-SATA5
T-SGPIO-1/T-SGPIO-2 Serial General Purpose Input/Output Headers
UIOP
(B/P) USB0/1
F/P USB 2/3 4/5, 6, 7
VGA
LED
LE1
LE2
Warning! To provide adequate power to the add-on cards installed on the mother-
board, please connect the UIOP PWR connector to the power supply for these cards
to work properly.
X8DTU/X8DTU-F Quick Reference
Description
COM1/COM2 Serial Port/Header
System/CPU Fan Headers (Fans 7~8: CPU Fans)
IPMB I C Header (for an IPMI Card) (X8DTU-F)
2
Speaker/Power LED Header (Pins 4~7: Speaker)
Front Panel Control Connector
Chassis Intrusion Header
Overheat LED Header
Power Supply SMBbus I
20-pin ATX Main Power Connector
8-pin Secondary PWR Connector (Warnings on P.1-4)
Rear Unit Identifier Switch
Gigabit Ethernet (RJ45) Ports
IPMI 2.0 Dedicated LAN (X8DTU-F)
(Intel South Bridge) SATA Ports
Universal IO Riser Card Power Connector (Required
for Add-on cards) (See the Warning below.)
(Back Panel) Universal Serial Bus (USB) Ports
Front Panel Accessible USB Headers
Video Port
Description
Onboard Standby PWR warning LED Indicator
Unit Identifier LED
Default Setting
(See Chapter 2)
Off (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
C Header
2
1-5
Chapter 1: Introduction