Jumper Description; Connector Description - Supermicro X11DPH-Tq User Manual

Quick Reference Table
Jumper Description
JBT1 CMOS Clear
JPG1 VGA Enable
JPL1 LAN1/LAN2 Enable
JPME1 ME Recovery
JPME2 ME Manufacturing Mode
JVRM1 VRM SMB Clock (to BMC or PCH)
JVRM2 VRM SMB Data (to BMC or PCH)
JWD1 Watch Dog Timer Enable
Connector Description
BT1 Onboard CMOS battery
COM1 COM port on the I/O back panel
FAN1~6, FANA/FANB System/cooling fan headers
IPMI_LAN Dedicated IPMI LAN port
I-SATA0~3, I-SATA4~7 SATA 3.0 Ports supported by the Intel PCH
JD1 Speaker header
JF1 Front control panel header
JHFI1 Host Fabric Interface (HFI) sideband connection header used for the HFI carrier card
JHSSI High-Speed Serial Interface (HSSI) card header
JIPMB1 4-pin External I
JL1 Chassis intrusion header
JNCSI Network Controller Sideband Interface (NCSI) header
JPI C1 Power I
2
JPWR1, JPWR2, JPWR4 8-pin power supply connectors
JPWR3 24-pin ATX main power supply connector
JRK1 Intel RAID key for NVMe SDD
JSD1, JSD2 SATA DOM (Device-on-Module) power connectors
JSDCARD1 Micro SD card slot
JSTBY1 Standby power header
JTPM1 Trusted Platform Module (TPM)/Port 80 connector
JUIDB1 Unit Identifier (UID) switch
LAN1, LAN2 10GbE LAN ports (for the X11DPH-T(q)) and Gigabit LAN ports (for the X11DPH-i)
M.2-C1, M.2-C2 M.2 slots
MH4, MH11 M.2 mounting holes
(CPU1) SLOT1, SLOT3,
PCI-Express 3.0 x8 Slots supported by CPU1
SLOT6, SLOT7
C Header (for an IPMI card)
2
C System Management Bus (SMBus) header
2
13
Chapter 1: Introduction
Default Setting
Open (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Normal)
On (Normal: SMB Clock to BMC)
On (Normal: SMB Clock to BMC)
Pins 1-2 (Reset)