Table of Contents
Advertisement
Quick Reference Table
Jumper
Description
J17
Power-Failure Throttling Enable
JBT1
CMOS Clear
JPG1
VGA Enable/Disable
JPME1
Manufacturing Mode Select
JWD1
Watch Dog Enable
Connector
Description
JBAT1
Onboard COMOS battery
COM1
Backplane COM port
FAN1-FAN10
System/CPU fan headers (FAN 1- FAN 10)
IPMI_LAN
Dedicated IPMI LAN port
J12VSB
12V standby power connector
JF1
Front control panel header
JL1
Chassis Intrusion header
JPWR1-JPWR4
12V 8-pin power connectors 1-4 for use of onboard GPU devices
JPWR5-JPWR7
12V 8-pin power connectors 5-7 for use of back panel devices
JRK1
Onboard RAID Key header
JSD1/JSD2
SATA DOM power connectors for onboard SATA devices
JSTBY1
Onboard 5V standby power header
JTPM1
Trusted Platform Module/Port 80 connector
SXB1A/SXB1B/SXB1C
WIO 2x16 (PCI-E 3.0) slot (for CPU2 Port1/ CPU2 Port2) (J18/J19/J20)
SXB2
WIO x8 (PCI-E 3.0) slot (for CPU2 Port3)
SXB3A/SXB3B/SXB3C
Ultra IO x40 slot (for CPU1 Port3/CPU1 Port1/CPU1 Port2) (J21/J22/J23)
PCI-E 3.0 riser card slot with support of 56 lanes (for CPU2 Port3/CPU3 Port2/CPU3 Port3/ CPU3
SXB4A/SXB4B
Port1) (J26/J27)
PCI-E 3.0 riser card slot with support of 48 lanes (for CPU4 Port1/CPU4 Port3/CPU4 Port2) (J29/
SXB5A/SXB5B
J30)
I-SATA0-3, I-SATA4-7
SATA 3.0 ports 0-3 & 4-7 supported by Intel® PCH
S-SATA0-3
S-SATA 3.0 ports 0-3 supported by Intel® SCU
S-SATA4/5
S-SATA 3.0 ports 4/5 with power-pins built in with support of Super DOM (Device-On-Module)
USB0/1 (JUSB2)
Universal Serial Bus (USB) header for two USB 2.0 connections for front access support
USB2/3 (JUSB3)
Back panel USB 3.0 ports 2/3
USB4 (JUSB1)
Type A USB 3.0 header
PSU1/PSU2 (J24/J25)
Power Supply Unit (PSU) 1/ Power Supply Unit 2 for system use
UID (JUIDB1)
Unit Identifier (UID) switch
VGA
VGA port
Default Setting
Pins 1-2 (Normal)
Open (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Reset)
13
Chapter 1: Introduction
Advertisement
Table of Contents
