HP D5970A - NetServer - LCII Reference Manual page 16

Chapter 1
NOTE For both safety and accessibility, always start assembly at the
bottom of the rack and work upward.
4. Be sure to locate and place rack nuts along the front outside face of the
vertical column before placing each component on its rails or base. The
pre-positioning of rack nuts allows the front of the component to be
secured to the front of the rack. (Some units use threaded inserts or bar
nuts, and require no rack nuts to secure the unit to the rack.)
5. Mount each unit on its accompanying rails, brackets, or slides.
CAUTION
A tip-over hazard exists. Servers are heavy and may be
awkward to position on their mounting rails. Therefore,
always minimize the weight to be mounted into the rack by
removing power supplies and hard disk drives.
When each component is correctly secured in the rack, replace disk drives
and power supplies and add the front panel (bezel) to the unit.
6. Proceed with units one by one, from the bottom of the rack to the top. Fill
any gaps with filler panels.
10. Connect and Route Cables
NOTE
Illustrated information about cabling the HP NetServer LXr
8500 in the rack is available in Chapter 3 of this Cabling
Reference Guide, which describes the procedures for
connecting and routing cables.
Generally, do the following to ensure cables are correctly connected and managed:
Prepare to Cable the HP NetServer LXr 8500
Determine which components will be connected to each server.
Attach Cable Guides to the rack column. See instructions included with
Cable Guides.
Attach Cable Management Arm to rear of server and to the rack column.
12
Preparation for Cabling the HP NetServer LXr8500