System Board; System Board Switch Settings - HP D5970A - NetServer - LCII Service & Reference Manual

System Board

Power Switch
and Activity LED
Connector
Bank A
Memory SIMM
Bank B
Connectors
Bank C

System Board Switch Settings

Switch Factory
position preset
1 - 5 (See table
below)
6 Open
7 Open
8 Closed
9 Open
10 (See table
below)
44
System Board
Retaining Latch
Processor chip
Power Supply
Connector
Select processor speed settings. The switch positions may need to be
changed when upgrading the processor (see table below).
Resets the CMOS configuration to the default values. Set the switch to the
closed position and restart the NetServer to reset the CMOS. Return the
switch to the open position and restart the NetServer to return to normal
operation.
Clears the password. Set the switch to the closed position and restart the
NetServer to clear the password. Return the switch to the open position and
restart the NetServer to return to normal operation.
Enable or disable space bar power-on. If you want to enable this feature, set
this switch to Closed. If you want to disable it, set this switch to Open. This
feature must also be configured in the BIOS using the SETUP utility.
Open = normal operation
Closed = Clear system product ID
Sets the processor supply voltage (see table below).
Open = 3.3V
Closed = 3.5V
DIP Switch Package
Battery
IDE 1 Connector
IDE 2 Connector
Flexible disk connector
Definition:
Com 1 Serial
Port Connector
Com 2 Serial
Port Connector
Parallel Port
Connector
Mouse Connector
Keyboard Connector
Display Monitor
Connector